Microscope light bulbs, because of different work different hours and ordered to. Ifthe bulbs replaced, be sure to zero out the system, and avoid any unnecessary machine damage. Each time you switch switches the lighting system is to be closed or brightness to a minimum in order to avoid sudden high impact damage to the light source.
In order to meet the surgical procedures in the selection of the surgical site, view size, definition of requirements, doctors can displacement through foot control boardmediation such as aperture, focal length, high and low. Adjustment when you're moving, slowly, and when it reaches the limit position, to stop immediately, Chrono transfer caused damage motor control failure.
Microscope use after a period of time, joint lock will appear dead or loose phenomenon, only joint lock according to the situation return to normal working condition. Each time before using the microscope no loose joints should be routinely inspected,so as not to cause unnecessary trouble in the surgery.
After each use, cotton cleaning wipe away dirt on the microscope, or too long it is difficult to clean. Microscope cover well, make it in a well-ventilated, dry, dust-free, non-corrosive gas environment.
Establishment of a maintenance system, adjusted by professionals for maintenancechecks on a regular basis, the necessary mechanical systems, observation systems, lighting systems, display systems, repair and maintenance of circuit. In short, be careful when you use the microscope, not rough handling. To prolong the operating microscope, had to rely on staff serious working attitude and the attention and care of the microscope, so that it is in good condition, to function better.